BlogExplore all content KuRan created for youBarcode-Based Tightening Program Selection: How to Map Product Codes to ProgramsA barcode scanner may read a product label correctly while the workstation still calls the wrong tightening task. On a […] Read More RS-485 vs 0–10 V Torque Arm Signals: A Controller Compatibility GuideChoosing between RS-485 and 0–10 V torque arm position signals starts with the receiving controller. A matching interface label is […] Read More Vertical, Horizontal and Angled Tightening: How Orientation Affects Torque Arm DesignA torque arm that works comfortably above a component may become awkward when the tool must reach a side face […] Read More How to Plan a Multi-Point Tightening Workstation for Engine AssemblyA multi-point tightening workstation for engine assembly should connect every required fastener to an approved process, a reachable tool position, […] Read More How Should a Tightening Workstation Handle NOK Results and Rework?A tightening tool reports NOK, but the operator still has a partly assembled product in the fixture and a queue […] Read More How to Map Fastening Points for a Torque Reaction Arm WorkstationSelecting a torque reaction arm by torque capacity and nominal reach alone does not guarantee that every fastener will be […] Read More Previous Page1 Page2 Page3 Page4 Page5 Next
